Two-wheeled motorcycles. Positioning of lighting and light-signalling devicesThis International Standard specifies the requirements for the positioning of lighting and light signalling devices when fitted to a two wheeled motorcycle as defined in ISO 3833. It does not specify the installation of any of these devices.

A reduced need for inspection by regulators

test methods and performance criteria for aspirating smoke detectors for use in fire detection and fire alarm systems installed in buildings

This part of the EN 16157 series specifies the informational structures

The range of pressure designations for butt welding end valves

and of hot or cold water not intended for human consumption at normal ambient temperature conditions within the following limits:

It applies to doors that are supplied fully finished

Load-bearing joints are covered by BS EN ISO 17660-1

Equipment suitability

This British Standard specifies the installation (see note) of non-domestic gas-fired tumble dryers and rotary ironers burning 2nd and 3rd family gases

BS EN 60335-2-11 does not apply to:

cold (operational) tests

infrequent and mostly unidirectional