Iceriver KS0/ KS0 Pro Centered Forced Air Shroud for 120mm fanThis is a 3D printed shroud for the Iceriver KS0 and KS0 Pro. This shroud has the fan centered and will not lay flat, but it stands on its side without issue. This auction is for the Shroud only and does not include a fan or miner. Requires a 120mm fan and 4 screws to attach the fan to the shroud, it is a slip fit and is nice and tight. I tested these with very basic 120mm case fans, they run silent and significantly improve cooling. Temps at stock

The baby stone dragon is roughly 8 inches long and does not come painted

A 205mm wheelbase body is optional

I have tested the generic Sumind gears and they work well

The Monitor seems to support this but Pool speed in inconclusive for me

Many of the Dragons in the Mystery boxes will  be in colors that I chose not to use for the primary lines

I'm using an Arctic P14 1700 RPM fan

Going up is easier than reducing the wheelbase

I tested these with very basic 120mm case fans

All files are being released on Cults3D if you purchase any of the kits below ask and I will send you a 50% coupon for cults3d to get all the current files and future upgrades

M3 Screws 2x35

The images are examples of dragons that could be included in the shipment

This is a solid rear axle rc car