Factory tourThe Tour The tour starts with an introduction to Douk and fellow tour vistors, followed by a brief trip around the workshop. Then we will go through the process in chronological order in detail getting hands on with the materials used and examples of the board at various stages. After each stage of the process is explained we will answer any questions along the way. Once the whole process has been explained we will again answer any questions about the

we cut and grind the excess

Featuring a Hybrid double Rocker profile and Asymmetrical Sidecut

An Ex Demo board

sanding and finishing it properly by hand

A proper T-shirt

If you are not sure what service you require then get in contact and send us some photos of your skis/snowboard and we can recommend the service for you

Precision edge tuning for maximum control

with a camber zone under each foot for edge hold and pop when you need it

swallow-tail powder board is built to surf the white waves

The Works 5 panel Cap

Sintered base - fast and hardwearing

surf-inspired experience