Mid Shaft Nut Tool | 4-Prong | Talaria X34 Pin Jack Shaft Tool for Talaria X3 Whether you call it a mid shaft, jack shaft, or intermediate shaft, removing the stock castle nut is one of the first steps when performing maintenance or upgrades on your Talaria X3. DirtyBikes 4 Pin Jack Shaft Tool is designed to fit the factory 4 prong castle nut and works with a 3 8" ratchet or breaker bar to make removal and installation easier, cleaner, and more secure than trying to improvise with the wrong

while the tread design gives predictable control in loose or soft ground

Exact Wheel and Tire Setup that "HarrySpama" uses on his Strike

Rear spacer catch is slot-cut for easier rear wheel removal

2 hose clamps

1 for hand brake & 1 for foot brake

TX 300 (Brembo caliper) 2017

Tighten the bleeder nipple all the way down and remove the fuel hose

NO COMPROMISES

Frequently Asked Questions

Time: 60 minutes for basic setup

or wet conditions

Motor mount left front (Qty 1)