Miller Slip Type NozzleNon threaded replacement gun nozzle with 1 2 inch (13 mm) diameter orifice. Contact tip is flush with end of nozzle. Nozzles focus the shielding gas as close to the welding arc as possible to minimize spatter. For use with M 25 and M 40 MIG gun (standard gun on most Millermatic 200, 210, 212, 250, 251, 252, 300 and Vintage MIG welders).

the unit is designed to give a minimum of three minutes to have time to equalize the refrigerant pressure to optimize cycling

pulling capacity

production and repair operations

The silicon addition improves puddle fluidity

More leverage for lifting unit on and off truck beds

while the deep ribs provide strength and weatherproof construction

XT30C and XT40 plasma torches

this option is not recommended for most exterior residential doors

Spool canister rotates 180°

you would need to purchase the SG100 spoolgun (K4360-1)

Angled All Aluminum Drive System: Robust wire drive with Quick Select™ drive roll and calibrated tension knob creates consistent feeding and easy setup for up to 15-foot MIG guns

Abrasion-resistant