Door leaves. Height, width, thickness and squareness. Tolerance classes1 Scope This standard gives the tolerance limits for specified dimensions of height, width and thickness, and for squareness of door leaves. It applies to door leaves which are supplied without, and independent of, any frames. t does not appl to te leaves of door sets. NOTE : Compliance with the tolerance limits given in this standard does not imply that this would necessarily produce a perfect fit between door leaves and frames.

These assertions enable a user of this part of ISO/IEC 24709 (such as a testing laboratory) to test the conformance to ISO/IEC 19784-1 (BioAPI 2

flow rate and physical strength

Note: The term "refrigerating system" used in this European Standard includes heat pumps

This document specifies the requirements and test procedures for 360° visibility of sit-on and stand-on self-propelled

This part of ISO 25745 only considers the energy performance during the operational portion of the life cycle of the lifts

bacitracin-zinc

The standard can be used to monitor and improve computer systems and the way you share information

This part of ISO/IEC 19784 defines the Application Programming Interface (API) and Service Provider Interface (SPI) for standard interfaces within a biometric system that support the provision of that biometric system using components from multiple vendors

NOTE 3 Requirements for the digital addressable lighting interface of electronic control gear are given in IEC 62386

The specific transient test cycle covered by this part of ISO 8178 is applicable to compression-ignition engines for mobile use with a power output between 37 kW and 560 kW

The cadmium plating restricts the application to temperatures not exceeding 235 °C

) to achieve consistency of end-user information