Jumper Wire (Female to Female)These are female to female jumper wires used in connecting the female header pin of Arduino or any development board to plug in any other development board. They are simple wires that have connector pins at each end allowing them to be used to connect two points to each other. These are typically used with breadboards and other prototyping tools in order to make it easy to change a circuit as needed. 40 strip female to female jumper wire each cable

Simple step and direction control interface

Compatibility: All Micro USB Supported Smart Mobile Phones

This display contains a capacitive touch-type screen and a toughened glass touch panel with a 6H hardness that supports a variety of systems

Package Information:

8A/115VAC            0

it is very important to remember that a Zener diode should always be used along with a Zener resistor

Relays are basically used to control high voltage circuits with the help of low voltage signals

These are Carbon Film Resistor with a value of 820 ohm 1/2W and tolerance of ±5%

5W ~ 2W Air Leakage 3

Screw connector

It can be powered by supplying 5V-12V DC input

8 ohm 1/8W and tolerance of ±5%