Tamiya - Clamp Type Aluminum Wheel Hub, 6mm ThickThese machined aluminum hubs clamp to the wheel axle rather than the slip on plastic units found on many of Tamiya's kits. The use of aluminum wheel axle hubs result in a truer spinning wheel and added strength. Furthermore, the drive pin stays secure as the whole assembly is fastened with a hex screw. They are crafted in precision engineered aluminum. Compatible Chassis: CR 01, DF 02, DF 03, DT 02, DT 03, DT 03T, F103GT FF 03, FF 03 PRO, FF 04 EVO, M

This 31mm V2 tower is made to adapt the larger volume 31mm rear shock bodies (#91482

5x11x4mm Metal Shielded "Speed" Clutch Bearings (10)

100C discharge ratings

including a water-resistant high-power Reedy brushless speed control

in conjunction with the optional front chassis brace (COR00180-387-2) and rear chassis brace (COR00180-397-2)

A 6' hose is included

and wider propeller blades have been accurately reproduced

Comes with a commander torso figure and 2 marking options

The Full Armor Gundam from the Thunderbolt comic is getting re-released with accurate anime colors

LiFe cells can be stored in a fully charged state with little to no loss in stored power

a fifth incarnation incorporated amphibious capabilities

and dual water outlet