1JZ / 2JZ Yaris Coil Pack KitThis conversion kit is for Toyota Yaris coil packs installed on 1JZ non VVT i engine. The kit is recommended to be used with Bosch Ignition coil 0 986 AG0 502, BIC729 or Toyota OEM. This kit retains the factory crossover breathers that run between both cam covers. This kit is suitable for 1JZ non VVTi, 2JZ non VVTi and VVTi GTE variants but not yet tested on 1JZ VVTi (if the OEM bolt holes are the same then should fit also). The kit will also fit 2JZ

The Hilux pedal provides the advantage of running a DBW setup but also keeping the OEM look and feel of a cable pedal

The CKS Lab MA61 Drive By Wire Accelerator Pedal Kit bolts to the firewall allowing a Hilux pedal to be used as the pedal sensor for DBW setups

3x m10 washers

This is an installation kit only

This conversion kit is for all 1JZ and 2JZ engines and relocates the OEM alternator from the hot side to the cold side away from turbo heat

1JZ w/ Ross oversized balancer - 6PK1545

1x m10 x 20mm bolt

1x m10 x 90mm bolt

2JZ non VVTi and VVTi GTE variants but not yet tested on 1JZ VVTi (if the OEM bolt holes are the same then should fit also)

This kit works with the Toyota Hilux OEM pedal with part number 781200K010 or 781200K011

If your setup is not listed

This conversion kit is for Toyota Yaris coil packs installed on 1JZ non VVT-i engine