ActiveTarget Pole/Trolling Motor Combo Multi-View Transducer***All 3600 Series Mounts are now finished in a Hard Black Anodized coating and are no longer anodized in Natural. Clevis Pins and Cable Management Straps are no longer supplied with mounts. Mounts are now supplied with a stainless bolt locking nut. Also all Active Target Mounts are now supplied with plastic toothed inserts, so you no longer need to reuse the factory pieces*** Introducing out new Lowrance ActiveTarget Multi View Pole Trolling Motor

Introducing out new Garmin LiveScope LVS62 Multi-View Transducer Pole Mount

Biggest issue I see with today's large and expensive transducers is that installers are using 5/8" or 3/4" thick mounting boards which limits screw engagement to only 5/8" if using a 3/4" screw

Please confirm the dimensions of your trolling motor to the dimensions picture below to make sure your trolling motor will work with the mount

you will need to figure out the amount of swing distance from the center of the turret pole to trolling motor shaft and make sure the Trolling Motor shaft is in the "dead zone" area rotation (call me if you need to discuss your application

Our dedicated Minn Kota trolling motor mounts are purpose built for the built-in US2 sonar

These are not stocked but are made in runs of 6-10 pairs

so you no longer need to reuse the factory pieces

and the XM 14 74 MSI T

Twist and Let Go is all that is needed from switching Into and Back from Landscape View

Introducing our RTL3640 Lowrance ActiveTarget "Scout Only" Transducer Mount Combo

A mounting board that's as indestructible as our mounts

The color coordinated indicators also allow you to run the transducer at angles other than the "factory" settings which is especially useful on Perspective View