Plastics. Determination of matter extractable by organic solvents (conventional methods)1 Scope This International Standard specifies methods for the determination of components in plastics that can be extracted by hot organic liquids near their boiling points. For one special case, a so called cold extraction method is given in Annex B. The extractable components can be monomers, oligomers, polymers, plasticizers, stabilizers, etc. The kind and percentage of extractable matter influence the properties of plastics. The recommended

A measurement device to measure the depth of failures has been added

b) connection to a low-pressure (280 kPa to 600 kPa) supply from a medical gas pipeline system

1 Chipping machines according to EN 13525 and chipping machines with mechanical feed systems for the production of woodchips and shredding /grinding machines

for which modifications to the standard tests maybe necessary or special test conditions may need to be devised

Why should you use BS EN 15276-2- Condensed aerosol extinguishing systems

— Needle-free injection systems (ISO 21649)

PD CEN/TS 17303 provides methods and procedures for barcoding fish and fish products using defined mitochondrial cytochrome b and cytochrome c oxidase I gene segments

This standard applies to jointers for cutting into wood or similar material

BS EN IEC 60255-181 demonstrates the procedure for documenting the minimum requirements

BS EN 2349-308 provides users guidance on a test method for testing the coil current of relays and contactors

BS EN 61508-6 helps you to accurately apply the guidelines of IEC 61508-2 and IEC 61508-3 in your programmable electronic safety-related systems and enhance their functional safety

it can be applicable to the inside surface over a limited length from the ends of tubes