Collection, logistics & treatment requirements for WEEE - Treatment requirements for temperature exchange equipment and other WEEE containing VFC and/or VHCWhat is BS EN 50625 2 3 Collection, logistics & treatment requirements for WEEE about ? BS EN 50625 2 3 applies to the treatment of waste temperature exchange equipment, other WEEE containing VFC or VHC in refrigerants or blowing agents. BS EN 50625 2 3 applies to the treatment of temperature exchange equipment until waste status is fulfilled, or temperature exchange equipment fractions are recycled, recovered, or disposed of. BS EN 50625 2 3

The compression stress/strain characteristic differs from the indentation hardness characteristics (as determined in accordance with ISO 2439)

and other visible defects

The test method specified in BS EN 933-7 is applicable to particle size fractions di/Di where Di # 63 mm and di $ 4 mm

Two preparation methods are described in this test method:

Note 3: The titles of the publications referred to in BS 3553 are listed on the inside back cover

BS 6165 has been prepared under the direction of the Fire Standards Policy Committee and specifies requirements for non-refillable fire extinguishers of the aerosol type for various applications

PD CEN/TR 16797 provides a brief introduction as to how to declare performance for the potential release

BS EN 772-18 specifies calcium silicate masonry units that are conditioned by immersion in water in a prescribed way and are then subjected to repeated cycles of freezing and thawing

once correctly closed and locked

ISO 20140‑3 helps you make your manufacturing systems more environmentally friendly

BS EN 1337-6 on structural rocker bearings is useful for:

this Technical Report establishes a method for construction of datasets of different levels of difficulty