Founding. Technical conditions of delivery - Additional requirements for magnesium alloy castings1 Scope This part of EN 1559 specifies the additional technical delivery conditions for castings (see EN 1753) and cast anodes (see EN 12438) made from magnesium alloys. This part of EN 1559 applies to magnesium alloy castings produced in sand or permanent moulds or by pressure die casting, centrifugal casting, continuous casting or investment casting. This part of EN 1559 does not apply to ingots, bars, billets (or other shapes) for further

Machinery used in potentially explosive atmospheres and explosion prevention and protection

Screw and washer combinations

C and D respectively

the hazards are identified using the risk assessment principles as defined in ISO 12100 or by other means

published by the International Institute of Welding (IIW)

- Type II: Inflatable boats capable of taking a maximum motor power of 4

The information security management system preserves the confidentiality

Second source of supply

are used for electrotechnical components installed on vehicles other than railway rolling stock

BS EN 1090-3 gives options for specifying requirements to match project specific requirements and also applies to temporary aluminium structures

Immunity test requirements

• Diffusive catalytic combustion heaters