End mill holder Whistle-Notch HSK 63 - 16 - 100Application: For mounting straight shank tools and inclined flat according to DIN 1835 form E (Whistle Notch). Delivery: With clamping screw and axial adjustment bolt All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine

clamping depth = 36

Standard type without safety clutch

Especially in operations in toolmaking and mould making

Enables reduction to the next smallest insert holder

Calibration certificate

For d = 60 only with four fi xation screws according to DIN 912

Powder-coated

is prevented from attaching itself by vacuum

For mounting straight-shank tools in 2 µm-collets

Delivery with test certificate

One turning toolholder - four possibilities:

B showing the deviation of each block