Shrink chuck 4,5° SK 30 - 16 - 100Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

00005" / 0

without reduction

For d = 60 only with four fi xation screws according to DIN 912

05mm / 1/128"

Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system

For clamping tools with Morse taper shank and thread according to DIN 228-1 form A

For mounting straight-shank tools in 2 µm-collets

- Especially suitable fore wire EDM

Suitable for tool arbor with polygonal shank (PSC) - ISO 26623-1

- Calibration of the angular position of spindles of milling-turning centres

Stahlkörper allseitig geschliffen und gehärtet

A possible increase of axial force during the tapping process is reduced to a minimum