Shrink chuck 4,5° HSK 100 - 12 - 200Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Flute geometry with special design

For sealing tools with internal cooling in collet chucks

Inklusive Feder

bei Ø 6 – Ø 32 mm = h233

Axial sealed with two O-rings

critical factors for successful deep face grooving operations

Digital setting device Z-axis

M6 - M12 = 10

For mounting tools with straight shanks

Collets sealed with seal for IC DIN 6499 B (ISO 15488 B) ER-system

The clamping screw is drilled through

for clamping holders with coolant channels directly to the cutting edge