NB-IoT Antenna 2dBi High Gain Waterproof SMA MaleNB IoT Antenna 2dBi High Gain Waterproof SMA Male Specification Multiband Frequency: Including 700MHz and 900MHz Gain: 2dBi Input impedance: 50 Polarization: vertical Connector: SMA Male

such as the signals from various sensors

The board breaks out all major pins and makes it easy to incorporate this great chip into your next radio project

This click uses the MIC33153

S-type has the horizontal type of terminal block for the stackable purpose

Real PTZ with servos for directional control and varifocal lens for optical zoom now comes to the Raspberry Pi

Can distinguish which serial port connects to the device via port number

The function of identity packet function

Easy programming use Arduino IDE

It uses the 5V supply from your InterfaceKit or Hub and steps it up to 12V while simultaneously passing the 0-5V signal from the sensor into the Phidget cable

an event is fired in software

The 2x13 pin header on top is a pass through if you want to connect other cards using the GPIO-port

Specifications