Paints and varnishes. Determination of resistance to liquids - Spotting methods1 Scope This document specifies spotting methods for determining the resistance of an individual layer or multi layer system of coating materials to the effects of liquids or paste like products. These methods enable the testers to determine the effects of the test substance on the coating and, if necessary, to assess the damage to the substrate.

Door access

— steam turbines and/or generators with outputs greater than 40 MW and speeds of 1 500 r/min

both on surface and underwater

These classifications assist the surgeon in the selection of the appropriate implant for a specific case

marking and materials together with associated pressure/temperature (p/T) ratings

This method has been validated in field tests with special emphasis to dust concentrations around 5 mg/m3

Logistics management

All measurements are carried out at normal room conditions unless otherwise stated

This European Standard applies according to the laws and the regulations applicable in the territory of every national CEN member adopting the standard

with the smallest track gauge of the rear axle exceeding 1 150 mm

BS EN 62376 specifies the minimum operational and performance requirements and methods of testing for ECS (Electronic chart system)

NOTE 2 The term “reversed inverse regression” was suggested taking into account the history of regression analysis theory