Specification for ancillary components for masonry - Ties, tension straps, hangers and bracketsBS EN 845 1: 2003+Amendment 1: 2008 Specification for ancillary components for masonry. Ties, tension straps, hangers and brackets BS EN 845 1 specifies requirements for wall ties, tension straps, hangers and brackets for interconnecting masonry. It also gives requirements for connecting masonry to other parts of works and buildings including walls, floors, beams, and columns. Where anchors or fasteners are supplied or specified as part of an

and disposal

BS EN 12094-4 is a fourth of part of the BS EN 12094 series of standards that specifies requirements and describes test methods for container valve assemblies for CO2- high-pressure-

BS EN ISO 6360-1 is the international standard that specifies the code numbers for shanks

12 Testing the conformance of a metadata instance to a metadata standard

BS EN 10343 specifies the technical delivery requirements for the following steel products intended for use in the construction industry:

Valid conclusions can only be drawn from a limited number of units of the final product

integration with other management systems

BS EN 10130 applies to cold rolled uncoated low carbon steel flat products in rolled widths equal to or over 600 mm for cold forming

The standard identifies the eight quality management principles that can be used by senior managers to lead the organization towards improved performance

These design charts cannot be used to obtain the complete detailed design of any member but they may be used as an aid when analysing the cross section of a member at the ultimate limit state

attention is drawn to the fact that safety systems or national and local regulations might specify requirements for either resistance to fire performance (e

It is recognized that the operating characteristics of tubular cored electrodes can be modified by the use of pulsed current