Shrink chuck 3° SK 40 - 08 - 160Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

sleeves and tool arbors

The steel body is hardened and grinded all-round

5 x 58 x 18

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance2

All tool sizes can be combined

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance5

All collets with outside form DIN 6388 (ISO 10897) can be clamped

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

- Calibration of the angular position of spindles of milling-turning centres

chip breaking

For mounting straight-shank tools for woodworking in collets

• runout accuracy: = 0