Aluminum Wheel Bleeder HousingAluminum Bleeder Housing. Wheel disconnects allow for use of pneumatic bleeders to maintain constant air pressure and consistent stagger, can also be used for quick filling. Aluminum housings are a must for pavement cars that use higher air pressure or for dirt cars that need added protection. This design is made just like the plastic housings but are much stronger. The strength behind these Bleeder Housings is the billet aluminum housing. Comes

1 1/2" Kickout for arm/elbow room

50" Axles use a 46" Tie Rod

Width: 20 1/2"

Height: 1 3/8"

Holds up to 4 Set Up Blocks (not included)

Choose "3 Pack" in the package option above

Right Rib at 18"

Bottom "L" Tray craddles wing

Height: See dimensions tab

then press down on the inside handle

Length: For chassis with 18 1/2" spread (center to center) from bar below motor plate to rear K-Brace

Width (of brackets): 36"